Power Supply, 100W AC

RPS-AC-100W

RPS AC/DC Power Supply

Supported Voltage Range: 100 to 240VAC, 24VDC Output

DATA SHEET

RPS-AC-100W

Write your review

Power Supply, 100W AC

RPS-AC-100W

RPS AC/DC Power Supply

Supported Voltage Range: 100 to 240VAC, 24VDC Output

DATA SHEET

Write your review

16 other products in the same category

Brands: Tycon Systems

TP-MS4X4

Gigabit Mid Span, High Power 1A per port, Univolt PoE Injector - 4 PoE output ports with the same or different PoE voltage.

Features

- High Power, Gigabit 4 Port Midspan POE Injector

- Up to 1A per Individual Port

- Universal PoE Voltage 12VDC to 57VDC.

- Surge Protection on Data Inputs.

- Supports Different PoE Voltage on Each Port. 

- Supports Reverse Voltage on Individual Ports.

- Powers 802.3af and Passive PoE Devices.

DATA SHEET

Brands: Tycon Systems

TP-DCDC-1224-HP

The TP-DCDC-HP Series of DC to DC converters offered by Tycon Power® are a low cost and high reliability solution for those requiring 24VDC or 56VDC Power over Ethernet voltage from a 12V, 24V or 48V battery system. They have an integrated PoE injector. Passive PoE and 802.3at models are available.

The input and output are isolated so the units can accept minus voltage on input and can be wired for positive voltage on the output for those systems which are negative voltage based.

If the remote device does not support power over Ethernet, splitters (POE-SPLT-S) are available to split the data and DC voltage at the remote device. If the remote device requires reverse voltage the POE-XOVER-S cable can be used.

DATA SHEET

Brands: Tycon Systems

TP-SW5G-24

The SW5 Series Power over Ethernet (PoE) switches offered by Tycon Power® are fully automatic high speed 5 port Ethernet switches with up to 2A of PoE power per port.

IEEE802.3af/at Compliant 48VDC 10/100/1000MB PoE Switch. Switch accepts 12-36VDC power via a wire terminal connector on the back of the Switch or via 48VDC PoE into the 802.3af/at compliant uplink port (90W max). Perfect for remote solar/battery systems. 35W per port. 70W Max Total.

On the universal voltage models (“-NC”) the PoE output voltage = the input voltage so it is universal in its application. The Ethernet spec supports distances up to 100m (328 feet) between the PoE switch and the remote device.

DATA SHEET

Brands: Tycon Systems

TP-DCDC-4856G-VHP

The Gigabit compatible TP-DCDC-2456G-VHP and TP-DCDC4856G-VHP area special very high power DC to DC converters / PoE inserters designed especially for Ubiquiti airFiber™ antenna systems and other systems which require high power passive PoE such as Axis High Power PoE PTZ security cameras. The unique PoE inserter supplies 56VDC PoE power on all 8 Ethernet wires.

They have two isolated inputs for connecting 2 power sources, like a primary and backup power source. They have various protections for surge, short circuit and overload. The input and output are isolated.

DATA SHEET

Brands: Tycon Systems

TP-VRHP-4824

Voltage Converter 36-72VDC Input, 24VDC @ 2.5A 70W Regulated output. 

The TP-VRHP-4824 is a 70W voltage converter/regulator which accepts an input of 36VDC to 72VDC and provides a regulated output of 24VDC @ 3A 70W. Input and outputs are wire terminals for wire up to 12AWG. Operates from -30 to +65 deg C. 

DATA SHEET

Brands: Tycon Systems

PSDIN-48-240W

The PSDIN Series of Industrial DIN Rail mount high efficiency switching power supplies operate over a wide temperature range of -40C to +70C. There are two models to supply 120W or 240W. The input is 90 to 264VAC auto-ranging with wire terminal connections. The output is 48VDC nominal with an adjustment range from 47VDC to 56VDC. There is a switch for single or parallel operation. Two 240W supplies operating in parallel will provide 480W total power. There is an alarm output to provide a dry contact closure to trigger an alarm if the DC output fails, like during a grid power failure. The relay is closed when DC output is normal and open when DC output is in fault condition due to overload or safety shutdown.

DATA SHEET

Brands: Tycon Systems

TP-DCDC-2USB-48

USB Powered 48V Passive PoE inserter. 48VDC 12W Passive PoE output with 2 USB power inputs. 10/100Mb

The TP-DCDC-2USB-48 Passive Power Over Ethernet Power Source offered by Tycon Power Systems is a unique 48VDC Passive PoE injector powered by two USB ports. They work by supplying power to the remote device on the 4 unused Ethernet pins 4,5(+) and 7,8(-). The Ethernet spec supports distances up to 100m (328 feet).

DATA SHEET

Brands: Tycon Systems

TP-SW5G-NC

Universal Voltage 10/100/1000MB PoE Switch. Switch accepts universal voltage (12- 57VDC) via the wire terminal connector on the back of the switch. Also accepts 12-57VDC (1A max) Passive PoE input on port 5. 1A per port

On the universal voltage models (“-NC”) the PoE output voltage = the input voltage so it is universal in its application. The Ethernet spec supports distances up to 100m (328 feet) between the PoE switch and the remote device.

Tycon Power® sells a variety of power supplies in 60W, 120W and 180W sizes. 18VDC, 24VDC and 48VDC are available. All the Switches have DIN Rail mounts included for convenient DIN rail mounting.

DATA SHEET

Brands: Tycon Systems

TP-DCDC-1218

9-36VDC IN, 18V 18W Passive PoE OUT, DC to DC Converter/PoE inserter. 10/100Mb.

The TP-DCDC-1218 DC to DC converters offered by Tycon Power Systems are a low cost and high reliability solution for those requiring 18VDC Power Over Ethernet voltage from a 12 or 24V battery system. 

They have an integrated PoE injector to apply the regulated 18VDC to the CAT5 Ethernet cable. The input voltage must be between 9VDC and 36VDC.

DATA SHEET

Brands: Tycon Systems

TP-VRHP-1256

Voltage Converter 10-15VDC Input, 56VDC @ 1.25A 70W Regulated output. 

The TP-VRHP-1256 is a 70W voltage converter/regulator which accepts an input of plus or minus 10VDC to 15VDC and provides a regulated output of 56VDC @ 1.25A 70W. These units are perfect for providing 56VDC voltage from 12VDC battery source like in a vehicular application or remote power application. Input and outputs are wire terminals for wire up to 12AWG. Operates from -30 to +65 deg C. 

DATA SHEET