R11e-LTE

R11e-LTE

R11e-LTE

The R11e-LTE is an LTE Cat-4 modem that delivers up to 150Mbps downlink and 50Mbps uplink data rate with 3G and 2G network fallback. This mini-PCIe form factor modem is designed for international bands.

It can be used with any of our products that have miniPCI-e slot (exceptions RB800 and RB4011).

DATA SHEET

R11e-LTE

Write your review

R11e-LTE

R11e-LTE

The R11e-LTE is an LTE Cat-4 modem that delivers up to 150Mbps downlink and 50Mbps uplink data rate with 3G and 2G network fallback. This mini-PCIe form factor modem is designed for international bands.

It can be used with any of our products that have miniPCI-e slot (exceptions RB800 and RB4011).

DATA SHEET

Write your review

16 other products in the same category

Brands: Mikrotik

RB912R-2nD-LTm&R11e-4G

The LtAP mini 4G kit is a small weatherproof wireless access point with a built in cellular modem that supports 4G (LTE) connectivity on LTE FDD bands 3 (1800MHz), 7 (2600MHz), 20 (800MHz) and 31 (450MHz), as well as LTE TDD bands 41n (2500MHz), 42 (3500MHz) and 43 (3700MHz).

The LtAP mini 4G kit also has one 10/100 Ethernet LAN port for your wired devices. The RS232 serial port gives you console access for debugging.

LtAP mini 4G kit has a special enclosure with a wall mounting kit, two SIM slots to alternate between cellular providers, and integrated GPS support, making this a perfect device for use in moving vehicles like cars, buses or trains.

DATA SHEET

Brands: Poynting

LPDA-92

This high-gain wideband directional antenna covers all international cellular, mobile and wireless data bands including GSM 900/GSM1800/UMTS/LTE bands and 2.3-2.7GHz licensed and unlicensed data bands. Its configuration is suitable for various wireless communications systems.

This antenna is unique in its combination of ultra wide-band operator with a consistent high-gain performance. It has been successfully used in extreme weather environments in Africa and Europe with close to zero failures.

A firm favourite, in any area where operators are having signal challenges. It is ideal for any application using the GSM network (LTE/HSPA/3G/EDGE/GPRS).

DATA SHEET

Brands: Mikrotik

R11e-4G

R11e-4G supports LTE FDD bands 3 (1800MHz), 7 (2600MHz), 20 (800MHz) and 31 (450MHz), as well as LTE TDD bands 41n (2500MHz), 42 (3500MHz) and 43 (3700MHz).

You are welcome to use it with our products that has miniPCIe slots, like LtAP mini, wAP R, RBM11G, RBM33G or others.

DATA SHEET

Brands: Mikrotik

RBwAPGR-5HacD2HnD&R11e-4G

The wAP ac 4G is an extremely cost-effective dual-band (2.4 / 5 GHz) home access point based on our popular weatherproof wAP form factor. It has two Gigabit Ethernet ports – you can use the device as a wired router with LTE backup via the Micro SIM slot. Alternatively, you can also enjoy wireless experience anywhere – indoors or outdoors. It can withstand temperatures from -30 C‎° to +60 C‎ and can be easily mounted on walls, ceilings or poles.

This device is powered by a four-core 716 MHz CPU and 128 MB RAM, capable of handling heavy loads. Dual-chain 2.4 GHz and dual-chain 5GHz wireless for dual concurrent AP coverage will solve most interference issues in a crowded environment. 

DATA SHEET

Brands: Mikrotik

RBwAPGR-5HacD2HnD&R11e-LTE

The wAP ac LTE is an extremely cost-effective dual-band (2.4 / 5 GHz) home access point based on our popular weatherproof wAP form factor. It has two Gigabit Ethernet ports – you can use the device as a wired router with LTE backup via the Micro SIM slot. Alternatively, you can also enjoy wireless experience anywhere – indoors or outdoors. It can withstand temperatures from -30 C‎° to +60 C‎ and can be easily mounted on walls, ceilings or poles.

This device is powered by a four-core 716 MHz CPU and 128 MB RAM, capable of handling heavy loads. Dual-chain 2.4 GHz and dual-chain 5GHz wireless for dual concurrent AP coverage will solve most interference issues in a crowded environment.

DATA SHEET 

Brands: Mikrotik

RB912R-2nD-LTm&R11e-LTE

The LtAP mini LTE kit is a small waterproof wireless access point with a built in cellular modem that supports 2G, 3G and 4G (LTE) connectivity on International LTE bands 1,2,3,7,8,20,38 and 40.

Connect to the LtAP mini’s built-in 802.11b/g/n wireless and access the LTE network from your phone or any other wireless device. The LtAP mini LTE also has one 10/100 Ethernet LAN port for your wired devices. The RS232 serial port gives you console access for debugging.

DATA SHEET

Brands: Mikrotik

R11e-LTE6

The R11e-LTE6 is an LTE CAT6 modem that delivers up to 300 Mbps downlink and 50 Mbps uplink data rate with 3G and 2G network fallback. CAT6 also features carrier aggregation and allows the device to use multiple bands at the same time. This miniPCIe form factor modem is designed for international bands. It can be used with any of our products that have miniPCIe slot (exceptions RB800 and RB4011).

DATA SHEET

Brands: Teltonika

TSW100

The TSW100 is the first industrial unmanaged switch from Teltonika Networks. It is equipped with five Gigabit Ethernet ports, four of which support IEEE802.3af and IEEE802.3at Power-over-Ethernet standards (PoE). Classified as power source equipment (PSE), it enables centralization of the power supply, providing up to 30 watts per port and reducing the effort for installing power. It has 10/100/1000 Mbps Ethernet ports for an economical high-bandwidth solution. 

DATA SHEET

Brands: Mikrotik

RBLHGR&R11e-LTE6

The new LHG LTE6 kit features a CAT6 LTE modem, which enables carrier aggregation and allows the device to use multiple bands at the same time. A huge advantage when there are a lot of LTE users in the area. It provides better responsiveness in a crowded environment and higher efficiency for weaker signal situations in the countryside. We have seen Internet speed doubling in rural areas after switching to CAT6, so there is no need to wait for cable network expansions.

DATA SHEET

Brands: Teltonika

TRB142

The TRB142 comes with a widely used RS232 interface for remote device management. It is equipped with mission-critical LTE Cat 1 capabilities and software based on OpenWRT, hence offering a high degree of customization.

This gateway is durable, offers a wide range of power supply voltages, and is compatible with Teltonika Networks Remote Management System (RMS).

DATA SHEET

Brands: Teltonika

RUT360

The RUT360 is an updated version of the all-time best-seller RUT240. This compact industrial cellular router offers a possibility to connect to the internet using cellular, Wi-Fi, and wired networks. RUT360 is equipped with two Ethernet interfaces, 802.11 b/g/n WiFi, and 4G LTE Cat 6 cellular module, offering data speeds up to 300 Mbps. Carrier aggregation functionality makes this compact device irreplaceable in areas or applications where cellular data speeds are limited.

DATA SHEET

Brands: Mikrotik

RBLHGR&R11e-4G

The LHG 4G kit is a device for remote locations that are within cellular network coverage. Mount it outdoors, on a pole, mast or any high enough structure, and connect even where cell phones can’t. Due to it’s large sized high gain 21dBi antenna, the device is capable to connect to cell towers in extreme rural locations, giving you the ability to provide last mile internet access where nothing else is available.

The unit is equipped with one Ethernet port, has a built in high quality Category 4 modem for speeds of up to 150 Mbit/s downlink and 50 Mbit/s uplink.

DATA SHEET

Brands: Teltonika

RUTXR1

The RUTXR1 is Teltonika\'s first-ever rack-mounted LTE Cat6 router with redundant power supplies and WAN interfaces, which can be conveniently placed in a server cabinet. It is equipped with dual SIM, USB, and Wave-2 802.11ac Dual Band WIFI. But what makes this product stand out from the rest of Teltonika Networks products are the SFP WAN and dedicated console ports. 

DATA SHEET

Brands: Mikrotik

RBLtAP-2HnD&R11e-4G

The new LtAP 4G kit is a compact 4G (LTE) capable weatherproof wireless access point – perfect for busy urban environment or off-the-grid outdoors networking. It has a built-in cellular modem that supports 4G (LTE) connectivity – no need for additional devices, it works out of the box.

Its high power 2.4 GHz 802.11b/g/n wireless capability provides secure access to LTE network from your phone or any other wireless device with up to 150 Mbps download speed. You can also use a Gigabit Ethernet LAN port for your wired devices. There are several power options – DC jack, POE-in and automotive.

DATA SHEET

Brands: Teltonika

RUT240

The RUT240 is an all-time bestseller industrial 4G LTE Wi-Fi router for professional M2M & IoT applications. It delivers high performance for mission-critical cellular communication in rigorous environments and is widely used for 4G backup, Remote Connection, Advanced VPN, and tunneling services in IoT networking solutions. WAN failover ensures automatic switch to alternative backup connection in case of any connectivity issues. The Wi-Fi is functional in both: Access point and Station mode at the same time.

DATA SHEET

Brands: Mikrotik

RBwAPR-2nD

The wAP R is a small weatherproof 2.4Ghz wireless access point with a miniPCI-e slot (so you can use your own LTE card) and LTE antennas. Unit comes with one 10/100 Ethernet LAN port for your wired devices.

The weatherproof device can be mounted outside your house, in the vehicle, on your porch or anywhere else where you need wireless access from your phone or computer. It also includes a desktop stand so you can put it inside the building near a window.

Unit has the several powering options - 9-30V PoE-in by Ethernet port, DC jack and automotive connector, very handy in mobile devices like car, bus or train.

DATA SHEET